Hello,
I just got this clock.
the motor need help to start running, and it is impossible to turn the main axle to set up the time if the motor is in place.
I took it apart and cleaned it. It starts better but is noisy. I didn't dare dismantle it any further. I can't find any information on this model.
the time setting knob cannot turn if the motor is in place.
when the motor is removed, it runs well, it is free and without jerking. but I don't see where there could be a disengagement???
the variable capacitor is driven by a rope as well as the needle, but it slips from time to time on its axis. is there anything to do?
the rotating foot is missing, if anyone can give me its dimensions, I will try to print one in 3D.
Best regards,
Benoit from Paris.
I just got this clock.
the motor need help to start running, and it is impossible to turn the main axle to set up the time if the motor is in place.
I took it apart and cleaned it. It starts better but is noisy. I didn't dare dismantle it any further. I can't find any information on this model.
the time setting knob cannot turn if the motor is in place.
when the motor is removed, it runs well, it is free and without jerking. but I don't see where there could be a disengagement???
the variable capacitor is driven by a rope as well as the needle, but it slips from time to time on its axis. is there anything to do?
the rotating foot is missing, if anyone can give me its dimensions, I will try to print one in 3D.
Best regards,
Benoit from Paris.
Attached Files